Basement Systems USA Before & After Photos

This install consisted of a Cleanspace Vapor Barrier, Waterguard and a SuperSump Pump with Battery Backup. The CleanSpace will direct any water that the customer had coming in through their block foundation, down to the waterguard which will then flow the water over to the SuperSump and pumped out of the basement. Our SuperSump Pump has a high end 1/3 hp Zoeller cast iron pump that pumps out over 2600 gallons per hour and when paired with our UltraSump Batter Back Up, this customers basement will stay dry during any power outages.

This customer had a slight bow in their block foundation which caused a  horizontal crack to develop. We sent our inspector Keith Miller out to the property and the best solution for this customer scenario was to install our Carbon Armor straps with Armor Locks.

The Carbon Armor Wall Stabilization system works by fusing our Carbon Armor Straps to ArmorLock strips that are anchored to heavy steel brackets that are attached to the rim joist. This system will immediately stabilize your foundation wall and stop any further inward movement.

This customer had a very damp and humid crawlspace that was causing mold to grow and the current insulation to fall down. To start off this project we first removed all the old damp insulation and then treated the mold with our Mold-X2 treatment. Next we installed our SilverGlo insulation wall panels and sprayed our RimTight spray foam insulation. Following our insulation install we put down our CleanSpace Vapor Barrier, install a SmartPump with Smart Pipe and then we finish up the install with a SaniDry Sedona Dehumidifier. 

This Elkton MD basement project consisted of 2 SuperSump Pumps an Ultra Sump Battery Back-Up, WaterGuard and CleanSpace Vapor Barrier. Now if any water tries to enter the basement during a rainstorm, this basement is fully protected. The Cleanspace will direct any water or moisture from the wall, down to the Waterguard. Once the water hits the Waterguard it will then flow over to the SuperSump to be pumped out and away from the house. In some cases, there could be a strong storm coming through and it knocks out the power, we got them covered on this as well since we installed an Ultra Sump Battery Back-Up. If and when power goes out, the Ultra Sump will kick on and keep the water flowing out of the basement.

This customer was interested in fixing up her dirt floor crawlspace. The space was very humid and there were beginning signs of mold present. We started here by removing all the old insulation and treating the mold with Mold X2. Next, we installed our SmartPipe crawlspace drain system and connected it to a SmartSump pump system. These two systems work together to discharge any incoming water that would otherwise collect and flood the crawlspace. Next, we installed SilverGlo insulated wall panels and added spray foam to the rim joists to create a more energy-efficient space. Lastly, we installed our CleanSpace Liner and vent covers.