Crawl Space Repair Before & After Photos

Click on a photo to enlarge.

Edgewood, MD Crawl Space Jacks Installed in a Dirt Floor Crawlspace

This house had problems with bouncy and sagging floors.  We installed three SmartJacks with galvanized steel beams to help carry the load of the joist. First we dig holes in the floor and filled them with crushed stone to provide a base for the SmartJacks.  Then we install the jacks with 8 foot long galvanized steel beams.  This solved the problem.  The floor is nice and sturdy.  

Exterior Discharge Line Installation in Aberdeen, MD

This homeowner was experiencing water and moisture within her dirt crawl space. Our team encapsulated the crawl space for her and included a pump for inside the space. This pump was connected to the shown discharge line to expel any collected water.

Waterproofing & Encapsulation in Denver PA

This homeowner had some trouble in her crawlspace after Hurricane Ida came through. There was standing water, mold and a musty smell. The customer was interested in waterproofing solutions and wanted the space encapsulated. Here we began removing all the old insulation and treating the area with Mold-X2 Cleaner and Botanical. Since the space had issues with standing water, we installed a SmartSump Sump Pump System to route away any incoming water. The old insulation was replaced with SilverGlo Thermal Insulated Panels. To encapsulate the space we laid down CleanSpace Drainage Matting followed by our CleanSpace Vapor Barrier Liner.

Narrow Musty Crawlspace in Havre De Grace MD

This narrow crawlspace was damp and had a strong musty odor traveling into the house. To correct the issue we first did a Mold x 2 Treatment, then proceeded with installing a Sanidry Sedona dehumidifier, Clean Space vapor barrier, SilverGlo insulation and a Smart Sump with Floor Alarm.

Smart Jack and Cleanspace install in NewHolland PA

Floors above the crawlspace were begining to sag in this new homeowners home. We came out it was deteremied the crawlspace needed a little more work than she had inspected.

There was moisture in the crawlspace causing areas of mold so first we treated the mold with a Mold X Treatment, then we installed a SilverGlo insulation, CleanSpace vapor barrier, drainage matting, waterguard a Smart Sump with floor alarm and Sani Dry Sedona dehumidifier. The floors above the crawlspace had failing joist supports and rotted sill plates so we corrected the issue by replacing 11 sill plates, installed 5 Supplemental Steal Beams and 9 Smart Jacks.

our service area

We serve the following areas

Our Locations:

Basement Systems USA
2092 East Old Philadelphia Road
Elkton, MD 21921
1-410-858-4610


Basement Systems USA
3000 Woods End Dr
Joppa, MD 21085
1-410-656-2558