Crawl Space Repair Before & After Photos

This was a very tough low crawlspace with lots of dampness. We had to clean it out first and remove all the organic material.  Then we installed a drainage system with a SmartSump to deal with the water issues.  The floor and walls where covered with our Cleanspace Encapsulation System to keep the moisture from the ground from evaporating into the air.  The result is a transformed, dry, and safe crawlspace. 

For this job, we came out to the customers home and replaced the current cinder blocks they were using as a support system, with our SmartJack System. Smart Jacks are adjustable supports that provide support to sagging floors and also lifts and restores them to their orignal position.

This homeowner was having issues with excess moisture in his crawlspace and wanted us to turn it into a clean, dry, energy-efficient space. Here we did an encapsulation with our CleanSpace Vapor Barrier System. We started by installing a SmartPipe Crawlspace Drain System with a SuperSump Pump System to eliminate any flooding water. We then laid down CleanSpace Drainage Matting which helps direct any water toward the perimeter drain. The old, tattered insulation was removed and replaced with SilverGlo Thermal Insulated Wall Panels, along with spray foam which we added to the rim joist area. Lastly, we wrapped the piers and walls with our CleanSpace Liner. 

This started off as a damp, moldy crawlspace. The customer was looking to remediate the mold and encapsulate the space. Here we started by removing the old insulation and cleaning the mold with our Mold X2 Cleaner and botanical solution. Next, Rim Tight Spray Foam was added to the joist area and SilverGlo thermal insulated panels were installed on the perimeter walls. We then laid down Cleanspace Drainage Matting and our Cleanspace Liner to encapsulate the space. To waterproof the area, we installed a Waterguard sub-floor drainage system along with a Supersump System which features a cast-iron Zoeller M63 sump pump, airtight lid and a floor drain. Lastly, we installed a Sanidry Sedona dehumidifier to keep the humidity low and an Ultrasump 4 battery back-up system to guard against flooding during a power outage.

The extremely high moisture levels in this customer's crawlspace had caused significant damage to the center support beam. Here we used existing piers and temporary jacks to lift the floor off the old cracked and rotting beam so we could replace it with new, pressure-treated lumber. Once we replaced the beam, we advised this customer to have a sump system and dehumidifier installed in order to keep the high moisture levels in check.